DC at Zak when using Vmware

Discussion in 'Closed' started by ijoe, Dec 24, 2015.

  1. ijoe
    Offline

    ijoe Member

    Joined:
    Aug 11, 2015
    Messages:
    16
    Likes Received:
    38
    Gender:
    Male
    Location:
    Toronto
    Country Flag:
    IGN:
    ijoe
    Level:
    189
    Guild:
    Komkommer
    IGN: ijoe
    Issue: A few seconds after zakum spawns, the game will crash

    Every time i use Vmware to go on a zak run, the game will completely crash and close when zakum spawns. No error messages will pop up either. This is a problem that only occurs when im using Vmware (if i dont use vmware, i'll crash anyway because of my nvidea graphics card) I've tried doing GFX each run, and I've even tried different settings of gfx when going into runs, yet nothing works. Re-installing maple didn't help either. I have contacted the gm Alyo, but her advice still did not fix the problem and it isn't possible for me to get rewarps either.
     
  2. NLtje
    Offline

    NLtje Well-Known Member

    Joined:
    Aug 1, 2015
    Messages:
    104
    Likes Received:
    30
    Gender:
    Male
    Country Flag:
    IGN:
    Redberry
    Level:
    15x
    Guild:
    Komkommer
    Bump <3
     
  3. Andreas
    Offline

    Andreas Donator

    Joined:
    May 31, 2014
    Messages:
    14,272
    Likes Received:
    4,335
    Gender:
    Male
    IGN:
    Egonic
    Level:
    19x
    Assuming you are using VMware workstation uninstall it and then download VMware player.
     
  4. ijoe
    Offline

    ijoe Member

    Joined:
    Aug 11, 2015
    Messages:
    16
    Likes Received:
    38
    Gender:
    Male
    Location:
    Toronto
    Country Flag:
    IGN:
    ijoe
    Level:
    189
    Guild:
    Komkommer
    Im using VMware player, and I followed everything on Tim's Vmware guide.
     

Share This Page